Cadence Flash F200-2 Guia de Resolução de Problemas Página 296

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 295
296 VoIP
vgwAudioTraceSetOutput
Syntax:
vgwAudioTraceSetOutput trace_output, "file_pathname"
Assign the output destination for the trace tool.
The following table describes the command parameters.
Table 85
Command parameters
Parameter Value Description
trace_output
1–4
Trace output destination, where:
1 = TTY
2 = SYSLOG
3 = File
4 = File and TTY
file_pathname "string"
Specify the file to output to if trace_output = 3 or 4.
Enclose the string in quotation marks.
You can enter the entire path name, or the file name
only. If you enter only the file name, the default path
is "C:/file_name".
The following example shows command output.
-> vgwAudioTraceSetOutput 3, "trace.txt"
value =0=0x0
vgwChStat
Syntax:
vgwChStat chNum
Print the statistics for a channel on the SMC card. This command applies
only to the SMC card. The MAC layer statistics, both the general and
channel-specific microEngine statistics are printed. If you assign a
DimDspStat = 1 prior to using this command (see “DimDspStat = 1/0”
(page 94)), the channel DSP statistics also print.
Note: When DimDspStat is assigned a value of 1, the DSP statistics
print at the end of every gateway channel call. Consider how busy the
card is before you enable this, as a block of data prints every time a call
completes until the variable is reset to 0. Be sure to assign DimDspStat
= 0 after you use the vgwChStat command.
The following example shows command output.
Nortel Communication Server 1000
Troubleshooting Guide for Distributors
NN43001-730 02.02 31 December 2009
Copyright © 2008-2009 Nortel Networks. All Rights Reserved.
.
Vista de página 295
1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 503 504

Comentários a estes Manuais

Sem comentários