
122 VoIP
Enter this command on the VGMC to generate a tone from the DSP to
the IP Phone or from the DSP to the TDM network. This command can
be useful when you debug speech path problems as a known good point
of reference to either end.
The following table describes the command parameters. Omitted
parameters use a value of 0.
Table 27
Command parameters
Parameter Value Description
side
0,1
Direction in which tone is generated, where:
0 = TDM
1 = TLAN
freq
0–3
Tone frequency, calculated as frequency =
500*(freq+1)Hz . For example, default = 0 produces
500 Hz tone.
duration
0–60
Tone duration in seconds. 0 = indefinitely.
The following example shows command output with all parameters
entered, and command defaults with no parameters entered.
-> genToneOn 0,1,2,15
Tone generated to IP, channel: 0, freq: 1500, duration:
15
value =0=0x0
-> genToneOn
Tone generated to TDM, channel: 0, freq: 500, duration: 0
value =0=0x0
genToneOff chNum
Syntax:
genToneOff chNum
Use this command on the VGMC to stop generating a tone started by the
genToneOn command.
The following example shows command output.
-> genToneOff
value =0=0x0
->
Nortel Communication Server 1000
Troubleshooting Guide for Distributors
NN43001-730 02.02 31 December 2009
Copyright © 2008-2009 Nortel Networks. All Rights Reserved.
.
Comentários a estes Manuais