Cadence Flash F100-5 Guia de Instalação descarregar pdf (Página 15)

4 CHANNEL AMPLIFER BRIDGED TO 2 CHANNELS

When bridging the four channel amplier, make sure that your nal woofer impedance on each bridged channel is no lower than 4 ohms. Set the Crossover Mode Switch to

Low Pass and begin by setting the crossover frequency control to 100Hz and tuning from there. The dashboard bass remote control works only on channels set to Low Pass.

RIGHT SUBWOOFER

MINIMUM IMPEDANCE

4 OHMS

LEFT SUBWOOFER

MINIMUM IMPEDANCE

4 OHMS

REMOTE SUBWOOFER

LEVEL CONTROL

CH 1-2

CROSSOVER MODE SWITCH

IN LOW PASS POSITION

CH 3-4

CROSSOVER MODE SWITCH

IN LOW PASS POSITION

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

INTRODUCTION 2
FEATURES 3
INSTALLATION BASICS 5
MOUNTING AND WIRING 7
GROUND POINT 8
REAR SPEAKER 8
REMOTE HOOK-UP OPTIONAL 8
WHEN USING HIGH LEVEL INPUT 8
2 CHANNEL AMP WIRING 9
3 CHANNEL MIXED MONO 10
2 CHANNEL AMP BRIDGED MONO 11
REMOTE TURN-ON 12
FRONT SPEAKERS 14
REAR SPEAKERS 14
SUBWOOFER 16
MINIMUM IMPEDANCE 16
4 CHANNEL WITH MIXED MONO 17
SETTINGS IN THIS 18
MODE SHOULD BE 18
FULL RANGE 18
ALL CROSSOVER 18
FIVE CHANNEL INPUT MODE 19
MONO BLOCK 2 OHM AMPLIFIERS 21
F500-1 / 21
F1200-1D 22
DVC 2 OHM SUBWOOFER 23
IN PARALLEL = 1 OHM LOAD 23
1 OHM MINIMUM LOAD 23
MASTER / SLAVE LINK 24
SWITCH SET TO MASTER 24
SWITCH SET TO SLAV E 24
REMOTE SUBWOOFER 24
LEVEL CONTROL 24
SPECIFICATIONS 28
SPEAKER WIRING CHART 30

Comentários a estes Manuais

Sem comentários

Cadence Flash F100-5 Guia de Instalação Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Amplificadores aúdio para automóveis Cadence Flash F100-5